Crankshaft Removal / Inspection; Crankcase Bearing Inspection - Polaris Ranger 500 2x4 2007 Service Manual

11. Turn the shaft until balancer counter weights clear the
crankshaft and remove the balancer shaft from the
crankcase.
12. Inspect the balancer drive gear and pump shaft drive gear.
13. Replace the shaft if gear teeth are abnormally worn or
damaged.
14. Inspect the balancer shaft bearings.
NOTE: Due to extremely close tolerances and
minimal wear, the balancer shaft ball bearings must
be inspected visually and by feel. Look for signs of
discoloration, scoring or galling. Turn the inner race
of each bearing. The bearings should turn smoothly
and quietly. The outer race of each bearing should
fit tightly in the crankcase. The inner race should be
firm with minimal side to side movement and no
detectable up and down movement.

Crankshaft Removal / Inspection

1. Remove the shim washer (C) from the crankshaft.
2. Support the PTO side crankcase and crankshaft; press the
crankshaft out. Be careful not to damage the crankcase
mating surface or connecting rod.
C
3. Use a feeler gauge to measure the connecting rod big end
side clearance.
Connecting Rod Big End Side Clearance:
Std: .0039-.0256" (.1-.65 mm)
Limit: .0315" (.80 mm)
4. Place the crankshaft in a truing stand or V-blocks and
measure the runout on both ends with a dial indicator.
Max Runout: .0024" (.06 mm)
5. Measure the connecting rod big end radial clearance.
Big End Radial Clearance:
Std: .0004-.0015" (.011-.038 mm)
Limit: .0020" (.05 mm)
6. Inspect the crankshaft main bearing journals for scoring
and abnormal wear.

Crankcase Bearing Inspection

1. Remove the seal from the PTO side crankcase.
2. Inspect the crankshaft main bearings, balancer shaft
bearings, and pump shaft bearing.
ENGINE
3
3.37