Driveshaft / Cv Joint Handling Tips; Front Drive Shaft (4X4); Removal - Polaris Ranger 500 2x4 2007 Service Manual

DRIVESHAFT / CV JOINT
HANDLING TIPS
Care should be exercised during driveshaft removal or when
servicing CV joints. Driveshaft components are precision parts.
Cleanliness and following these instructions is very important to
ensure proper shaft function and a normal service life.
• The complete driveshaft and joint should be handled by
getting hold of the interconnecting shaft to avoid
disassembly or potential damage to the driveshaft
joints.
• Over-angling of joints beyond their capacity could
result in boot or joint damage.
• Make sure surface-ground areas and splines of shaft are
protected during handling to avoid damage.
• Do not allow boots to come into contact with sharp
edges or hot engine and exhaust components.
• The driveshaft is not to be used as a lever arm to
position other suspension components.
• Never use a hammer or sharp tools to remove or to
install boot clamps.
• Be sure joints are thoroughly clean and that the proper
amount and type of grease is used to refill when joint
boots are replaced and when joints are cleaned. Refer
to text for grease capacity of CV joints and CV joint
boots.

FRONT DRIVE SHAFT (4X4)

Removal

1. Elevate front end and safely support machine under
footrest / frame area.
CAUTION
Serious injury may result if machine tips or falls.
Be sure machine is secure before beginning this
service procedure. Wear eye protection when
removing bearings and seals.
2. Check bearings for side play by grasping tire / wheel firmly
and checking for movement. It should rotate smoothly
without binding or rough spots.
3. Remove wheel nuts, washers, and wheel.
4. Remove the two brake caliper attaching bolts.
CAUTION: Do not hang the caliper by the brake line. Use
wire to hang the caliper to prevent possible damage to the
brake line.
5. Remove the hub spindle nut.
6. Remove hub.
FINAL DRIVE
7
7.9