FINAL DRIVE
SPECIAL TOOLS
PART NUMBER
2872608
8700226
TORQUE SPECIFICATIONS
Wheel, Hub, and Spindle Torque Table
ITEM
NUT TYPE
Aluminum Wheels
Lug Nut (1)
(Cast)
Steel Wheels
Flange Nut (2) 35 ft. lbs. (47 Nm)
(Black / Camo)
Front Spindle Nut
Rear & Center
Hub Retaining Nut
#1
Aluminum Wheel
(LE Models)
90 ft. lbs. (122 Nm)
FRONT HUB (2X4)
Hub Removal / Inspection
1.
Elevate front end and safely support machine under
footrest / frame area.
Serious injury may result if machine tips or falls.
Be sure machine is secure before beginning this
service procedure. Wear eye protection when
removing bearings and seals.
7.2
TOOL DESCRIPTION
Roller Pin Removal Tool
CV Boot Clamp Pliers
SPECIFICATION
90 ft. lbs. (122 Nm)
-
70 ft. lbs. (95 Nm)
-
110 ft. lbs. (150 Nm)
Steel Wheel
(Standard Models)
35 ft. lbs. (47 Nm)
CAUTION
2.
Check bearings for side play by grasping the tire / wheel
firmly and checking for movement. Grasp the top and
bottom of the tire. The tire should rotate smoothly without
binding or rough spots.
3.
Remove wheel nuts, washers, and wheel.
4.
Remove the two brake caliper attaching bolts.
CAUTION: Do not hang the caliper by the brake line. Use
wire to hang the caliper to prevent possible damage to the
brake line.
#2
5.
Remove hub cap, cotter pin, front spindle nut, and washer.
6.
Remove the spindle from the backside of the strut. Rotate
each bearing by hand and check for smooth rotation.
Visually inspect bearing for moisture, dirt, or corrosion.
Replace bearing if moisture, dirt, corrosion, or roughness
is evident. Inspect the spindle splines for wear.
Inspect Spindle Shaft
Inspect Bearing