Throttle Position Sensor Replacement; Throttle Position Sensor Initialization - Polaris Ranger 500 2x4 2007 Service Manual

Electronic fuel injection
Table of Contents

Advertisement

• Connect the test leads connected as shown in Figure 2
and the meter set to the "vdc" scale, move the throttle
open and closed slowly while reading the display. The
voltage should increase smoothly with no "jumps" or
decreases when the throttle is applied.
Tester 2201519
• If the TPS does not function correctly, replace it.
TPS Tester - Correct Reference Voltage
A 5 volt reference voltage signal from the test harness is
required for the TPS test to be accurate. Refer to the instructions
provided with the TPS Test Adapter Harness (2201519) or
follow these steps to check reference voltage.
• Harness Test: Insert black voltmeter probe into the
"Bk" test port.
• Connect the red meter probe into the "R" port and
verify the voltage is 4.99-5.01 vdc. If this reading is
low, verify the 9 volt battery is good or try a new 9 volt
battery.
No "Jumps" in read out
ELECTRONIC FUEL INJECTION

Throttle Position Sensor Replacement

NOTE: The
correct
position
established and set at the factory. If the TPS is
repositioned, replaced or loosened it must be
recalibrated.
1.
Remove the seat.
2.
Disconnect sensor from the engine harness.
3.
Loosen and rotate the throttle body (B) to gain access to the
retaining screws (if required).
4.
Remove the retaining screws and replace the sensor, but do
not tighten the screws at this point.
5.
Refer to "TPS Initialization" for setting the TPS voltage.

Throttle Position Sensor Initialization

The correct position of the throttle body idle
stop is established and set at the factory.
Do not loosen the throttle body idle stop or
alter the stop position in any fashion. If the
stop is repositioned, the entire throttle body
assembly must be replaced.
Establishing a TPS setting : This step is crucial as it sets the
TPS position using the fixed physical stop.
• Open and close throttle plate a couple of times to ensure
full throttle closing. Do not snap closed, as this could
cause unnecessary throttle plate to throttle body
interference and/or damage.
of
the
TPS
is
4
4.39

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ranger 500 4x4 2007Ranger 500 4x4 efi 2007

Table of Contents