Rear Drive; Exploded View; Rear Hub / Bearing Carrier; Hub Inspection / Removal - Polaris Ranger 500 2x4 2007 Service Manual

REAR DRIVE

Exploded View

Rear Gearcase
Rear Drive Axle
A-arm bolts
Nuts
Bushings
Shaft

REAR HUB / BEARING CARRIER

Hub Inspection
1. Support machine securely with rear wheels elevated.
2. Grasp wheel / hub and check for movement.
3. If movement is detected, inspect hub, hub nut torque and
bearing condition and correct as necessary.
CAUTION
Serious injury may result if machine tips or falls.
Be sure machine is secure before beginning this
service procedure. Wear eye protection when
removing bearings and seals.
A-arm bolts
Shaft
Bushings
Lower A-arm
Carrier Bolt
30 ft. lbs.
(41 Nm)
30 ft. lbs.
(41 Nm)
Shock
Upper A-arm
Bushings
Shaft
Bushings
Hub Removal
1. Elevate rear end and safely support machine under main
frame area.
2. Check bearings for side play by grasping the tire / wheel
firmly and checking for movement. Grasp the top and
bottom of the tire. The tire should rotate smoothly without
binding or rough spots.
3. Remove wheel nuts and wheel.
FINAL DRIVE
Coil
30 ft. lbs.
(41 Nm)
Caliper
18 ft. lbs.
(24 Nm)
Bearing
Snap Ring
7.25
7