Polaris Ranger 500 2x4 2007 Service Manual page 141

5. Remove the fuel tank vent hose
NOTE: A small amount of fuel may come out of the
fuel line or tank. Plug the fuel line and tank inlet or
use a shop towel during removal.
NOTE: Properly drain fuel into a suitable container.
6. Remove the RH rear fender and fuel cap.
7. Remove the two inner bolts that hold the fuel tank to the
frame.
ELECTRONIC FUEL INJECTION
8. Remove the two outer lower bolts that hold the fuel tank to
the frame.
9. Reinstall the fuel cap and carefully pull the fuel tank out the
RH side of the frame.
WARNING
Wear safety goggles while performing this
procedure, failure to do so could result
in serious injuries.
Fuel Tank Installation
1. Reinstall the pump/tank assembly.
2. Reinstall the four fuel tank mounting bolts that were
removed.
3. Reconnect the electrical harness. Install the fuel line and
vent line and verify they are secure.
4. Reinstall the RH rear fender.
5. Reconnect the negative battery cable. Test the fuel pump
by turning on the key and listening for the pump to activate.
4
4.33