Pdm Block Diagram; Pdm Isolation Tests (Non-Efi Models); Battery Voltage Test - Polaris Ranger 500 2x4 2007 Service Manual

Electronic fuel injection

Table of Contents

PDM Block Diagram

Test Procedure

Check DC volts across positive and negative battery terminals. Voltage should be above 12 VDC.

What does passing

If battery voltage is at or above 12 VDC, the battery and charging system are likely OK.

this test indicate?

What does failing

If battery voltage is below 12 VDC, the battery and charging system may be suspect. The battery must

this test indicate?

be charged and load tested.

Battery Voltage Test

Table of Contents