Table of Contents
Advertisement
FINAL DRIVE
4.
Remove the two brake caliper attaching bolts.
CAUTION: Do not hang the caliper by the brake line. Use
wire to hang the caliper to prevent possible damage to the
brake line.
5.
Remove hub cap, cotter pin, front spindle nut, and washer.
6.
Slide the rear hub from the rear drive axle.
7.26
7.
Remove the upper and lower control arm bolts from the rear
hub / bearing carrier.
8.
Remove the bearing carrier. Inspect the bearing again for
smoothness and side to side movement, replace as needed.
Hub Disassembly
1.
Remove outer snap ring (A).
A
2.
From the back side, tap on the outer bearing race with a drift
punch in the reliefs as shown.
NOTE: Drive bearing out evenly by tapping on outer
race only. Once bearing is at bottom of casting,
support casting on outer edges so bearing can be
removed.
Advertisement
Chapters
Table of Contents
Troubleshooting
