Polaris Ranger 500 2x4 2007 Service Manual page 67

ENGINE
• Drain the carburetor bowl
NOTE: Drain and properly dispose of the fuel.
• Disconnect fuel line
• Remove bolts securing carburetor to the dampener
bracket
• Remove carburetor
Vent Line
Throttle Cable
• Insert a shop towel into the carburetor flange to prevent
dirt from entering the intake port
Throttle Body Removal
• Disconnect throttle cable from the throttle body
• Loosen clamps on the throttle body boots
• Relieve fuel pressure and disconnect fuel line from fuel
rail
• Disconnect fuel injector harness, TPS harness, MAP
harness, and IAC harness
• Remove throttle body
Fuel Line
MAP
Fuel Injector
• Insert a shop towel into the intake manifold to prevent
dirt from entering the intake port
3.8
Bracket
IAC
TPS
6. Remove top motor mount bracket and dampener bracket.
Remove any heat shields.
7. Remove air box hose, rear clutch hose and the starter
positive cable
8. To help access the engine components, remove engine
access cover
Carb Model Shown
Engine Access
Cover
Lift Up
to Remove