CLUTCHING
Clutch Offset
IMPORTANT: Inspect clutch alignment and center
distance before adjusting offset.
1.
Install clutch alignment tool as shown.
Offset is correct when rear of tool contacts rear of inner sheave
with driven clutch pushed completely inward on shaft and bolt
torqued. Adjust offset by adding or removing spacer washers
between back of driven clutch and spacer as shown.
Spacer Washer PN: 7556401
6.10
Clutch Alignment Tool
should contact rear edge
of driven clutch sheave
Driven Clutch Offset
To adjust, add or remove
washers from behind the
driven clutch