Function Diagrams And Parameters; Messages Via Diagnostics Channels - Siemens SINAMICS S120 Function Manual

Communication
10.3 Communication via PROFINET IO
10.3.9.1

Function diagrams and parameters

Function diagrams (see SINAMICS S120/S150 List Manual)
• 2381
• 2382
• 2610
Overview of important parameters (see SINAMICS S120/S150 List Manual)
• r5600
• p5602[0...1]
• p5606[0...1]
• p5611
• p5612[0...1]
• r5613.0...1
10.3.10

Messages via diagnostics channels

Messages can be displayed not only via the well-known commissioning tools (STARTER,
SCOUT). After the activation of a diagnostic function, the messages are also transferred to
the higher-level controller via the standardized diagnostic channels. The messages are
evaluated there or forwarded for convenient display to the corresponding user interfaces
(SIMATIC HMI, TIA Portal, etc.). The messages are shown on the respective user interfaces
similarly as in STARTER.
In this way, problems or faults can be located immediately regardless of the tool currently
being used, and then corrected immediately. No further tools must therefore be called for the
correction.
800
Control commands / interrogation commands
States
Sequence control - sequencer
Pe hibernation ID
Pe hibernation pause time, minimum
Pe hibernation duration, maximum
Pe energy-saving properties, general
Pe energy-saving properties, mode-dependent
CO/BO: Pe energy-saving active/inactive
Function Manual, (FH1), 01/2013, 6SL3097-4AB00-0BP3
Drive functions