Active Infeed Open-Loop Control - Siemens SINAMICS S120 Function Manual

Hide thumbs Also See for SINAMICS S120:

Table of Contents

1.1 Active Infeed

Overview of important parameters (see SINAMICS S120/S150 List Manual)

Active Infeed open-loop control

The Active Line Module can be controlled via the BICO interconnection using terminals or

the fieldbus. The operating status is indicated on the operating display r0002. The missing

enable signals for operation (r0002 = 00) are mapped in parameter r0046. The EP terminals

(enable pulses) must be connected in accordance with the manual of the corresponding

power units. The drive unit must have been commissioned for the first time.

Acknowledging faults

Faults that are still present but the causes of which have been rectified can be

acknowledged using a 0/1 edge at the "1st acknowledge faults" signal (p2103).

Infeed identification method

Infeed identified inductance

Infeed DC-link capacitance identified

Infeed Vdc controller proportional gain

Function Manual, (FH1), 01/2013, 6SL3097-4AB00-0BP3

Drive functions

Show Quick Links

Table of Contents