Siemens LOGO! Series Manual page 53

LOGO! AM2
The illustration above shows an example of four-wire current measurement and two-wire
voltage measurement.
Connecting a two-wire sensor to the LOGO! AM2
Wire up the two-wire sensor's connecting wires as follows:
1. Connect the sensor's output to connection U (0 ... 10 V voltage measurement) or to
2. Connect the plus connector on the sensor to the 24 V supply voltage (L+).
3. Connect the ground connection of the current output M (on the right side of the sensor, as
LOGO!
Manual, 04/2011, A5E03556174-01
connection I (0/4 ... 20 mA current measurement) of the AM2 module.
shown in the figure above) to the corresponding M input (M1 or M2) on the AM2 module.
LOGO! installation and wiring
2.3 Wiring LOGO!
53