Siemens LOGO! Series Manual page 281

8. Press
9. Press
10. Press
11. Press
12. To confirm your selection, press OK.
LOGO!
Manual, 04/2011, A5E03556174-01
until LOGO! steps into the screen form for the first UDF block U01.
to move the cursor to "
square. Note that "1" in position "④" represents the first input of the UDF block U01 that
is connected to I1. "1" in position "
to Q1.
or to view other active inputs created in LOGO!Soft Comfort. The display
below shows you that the third input of U01 is connected to F1. If you want to change the
element connected to this third input "3", press OK.
to move the cursor to the F in F1, then press OK. You can select an element
from available lists.
UDF (User-Defined Function) (0BA7 only)
④
", then press OK. The cursor appears in a flashing solid
⑤
" represents the first output of U01 that is connected
281