Siemens LOGO! Series Manual page 419

Connecting the PLC to a Basic Panel PN
CAUTION
Data network security for communication via Ethernet
With Ethernet-based communication via PROFINET, the end user is himself responsible for
the security of his data network; the proper functioning of the data network cannot be
guaranteed in all circumstances, for example in the case of target attacks leading to an
overloading of the device.
NOTICE
RJ45 plug connector with 180° output required
The connection of the Basic Panels PN to the HMI device requires the RJ45 plug connector
"IE FC RJ45 Plug 2 x 2". You can find ordering information in the Accessories (Page 23)
section.
See also
Connecting the equipotential bonding circuit (Page 38)
Basic Panels
Operating Instructions, 04/2012, A5E02421799-03
PROFINET (LAN)
PROFINET
PROFINET
LAN
SIMATIC S7-200
SIMATIC S7-300/400
SIMATIC S7-1200
Mounting and connecting
3.3 Connecting the HMI device
Basic Panels PN can be connected to
the following SIMATIC PLCs:
SIMATIC S7-200
•
SIMATIC S7-300/400
•
SIMATIC S7 with PROFINET
•
interface
The connection is set up via
PROFINET/LAN.
47