Deleting Block Groups - Siemens LOGO! Series Manual

Programming LOGO!
3.7 Writing and starting the circuit program
3.7.9

Deleting block groups

Assuming you intend to delete the blocks B1 and B2 from the following circuit program
(corresponds with the circuit program in the "Second circuit program (Page 100)" topic),
proceed as follows:
1. Switch LOGO! to programming mode
2. To select "
3. To confirm "
4. To select "
5. To confirm "
6. To move the cursor to the input of Q1; that is, to B2, press :
7. Confirm with OK.
8. Now set the connector 'x' at output Q1 instead of block B2. To do so:
Result: LOGO! deletes block B2 because it is no longer used in the circuit. LOGO! also
deletes all blocks that connect to B2, in this case, block B1.
106
(as a reminder, refer to the topic "The four golden rules for operating LOGO! (Page 79)").
①
": Press
①
": Press OK
(If required, enter your password and confirm with OK.)
②
": Press
②
": Press OK
– Select the Colist: Press
– Accept the Co list: Press OK
– Select 'x': Press or
– Apply 'x': Press OK
or
or
or
Manual, 04/2011, A5E03556174-01
LOGO!