LOGO! installation and wiring
2.2 Installing/removing LOGO!
Removal
To remove LOGO!:
....... if you have installed only one LOGO! Base Module:
1. Insert a screwdriver into the eyelet at the bottom of the slide interlock and move the latch
2. Swing the LOGO! Base Module off the DIN rail.
....... if you have connected at least one expansion module to the LOGO! Base Module:
1. Using a screwdriver, push the integrated slide interlock to the right.
2. Slide the expansion module off towards the right.
3. Insert a screwdriver into the eyelet at the bottom of the slide interlock and lever it
4. Swing the expansion module off the profile rail.
42
downward.
downward.
Manual, 04/2011, A5E03556174-01
LOGO!