Siemens LOGO! Series Manual page 125

Changing LOGO! from slave mode to normal mode
LOGO! is now in the following view:
1. Move the cursor to "
2. Confirm "
3. Move the cursor to "
4. Confirm "
You have now successfully changed the LOGO! from slave mode to normal mode. LOGO!
restarts automatically and then displays the main menu.
Assigning a password from the LOGO!
1. Repeat steps 1 to 5 as described earlier in the topic "Changing LOGO! from normal mode
2. Move the cursor to "
3. Confirm "
4. Enter a password. The procedure is the same as for entering a password for the circuit
LOGO!
Manual, 04/2011, A5E03556174-01
①
①
": Press OK
②
②
": Press OK
to slave mode". LOGO! shows the following display:
①
①
": Press OK
program. (see the topic Password for circuit program protection (Page 91)).
3.8 Configuring additional functions for LOGO! (0BA7 only)
": Press or
": Press or
": Press or
Programming LOGO!
125