Data Log (0Ba7 Only) - Siemens LOGO! Series Manual

Data Log (0BA7 only)

You can configure a maximum of one Data Log for your circuit program using LOGO!Soft
Comfort. The Data Log is used to record process measurement variables of the selected
function blocks. You can add the Data Log instruction to your circuit program as you do with
a function block.
If you configured the Data Log for your circuit program, after transferring the program from
LOGO!Soft Comfort to LOGO!, you can edit the elements connected to the Data Log block.
For a detailed description of configuration of the Data Log function in LOGO!Soft Comfort,
refer to the online help for LOGO!Soft Comfort V7.0. From LOGO! 0BA7, you can only
configure elements connected to the Data Log block.
Editing elements connected to the Data Log block
LOGO! shows a Data Log function block with the following display:
If your circuit program in LOGO! contains a Data Log block configured from LOGO!Soft
Comfort, you can edit elements connected to this Data Log as follows:
1. Switch to programming mode. Press OK to step into the following display of your circuit
2. Press
LOGO!
Manual, 04/2011, A5E03556174-01
program:
to move the cursor until you see "L1" (The Data Log is identified with an L).
6
285