Siemens LOGO! Series Manual page 124

Programming LOGO!
3.8 Configuring additional functions for LOGO! (0BA7 only)
4. Confirm "
5. Move the cursor to
6. Confirm "
7. Confirm "
8. In this view, you enter the IP address of the LOGO! that you want to configure to be the
9. Confirm the setting: Press OK
You have now successfully changed LOGO! from normal mode to slave mode. LOGO!
restarts automatically and then displays the main menu. Stepping into the following view, you
can see that your LOGO! is now in slave mode:
Note
When LOGO! is in slave mode, you can not edit the circuit program from the slave LOGO!.
The menu command
124
②
": Press OK
LOGO! requires a password entry if one is assigned. If there is no password assigned on
the LOGO!, LOGO! directly displays the view in Step 5.
③
": Press
③
": Press OK
④
": Press OK
master of your slave LOGO!. Press
numbers. Press or
②
is not available in parameter assignment mode.
or
or to move the square cursor through the
to change the number.
Manual, 04/2011, A5E03556174-01
LOGO!