Commissioning A Project; Overview - Siemens LOGO! Series Manual

Commissioning a project

6.1

Overview

Configuration phase
A project – the process image of the working process – is created during configuration to
visualize automated working processes. The process displays for the project contain
displays for values and messages which provide information about process statuses. The
process control phase follows the configuration phase.
Process control phase
The project must be transferred to the HMI device if it is to be used in process control.
Another precondition for process control is that the HMI device is connected online to a PLC.
Current working processes - operating and observing - can then be subject to process
control.
Transferring the project to the HMI device
You can transfer a project to an HMI device as follows:
● Transfer from the configuring PC
● Restore from a PC using ProSave
Commissioning and recommissioning
Initial and re-start-ups differ in the following respects:
● When the HMI device is commissioned there is no project at first.
● When recommissioning, any project already on the HMI device is replaced.
Basic Panels
Operating Instructions, 04/2012, A5E02421799-03
In this case, an archived project is transferred from a PC to the HMI device. The
configuration software need not be installed on this PC.
ProSave is a service tool that enables you to manage data on your HMI device. With
ProSave, you can, for example, update the operating systems of the HMI device or
backup its data.
The HMI device is also in this state after the operating system has been updated.
6
89