7.2.1
Setting the time of day and date (LOGO! ... C)
You can set the time of day and the date
● in parameter assignment mode by means of the set menu ("Clock" menu item)
● in programming mode by means of the setup menu ("Clock" menu item)
To set the time of day and the date in parameter assignment mode:
1. Select parameter assignment mode (Page 288).
2. On the parameter assignment menu, select 'Set..': Press
3. Confirm 'Set..': Press OK
4. Move the '>' cursor to 'Clock': Press
5. Confirm 'Clock': Press OK
6. Move the '>' cursor to 'Set Clock': Press
7. Apply 'Set Clock': Press OK
8. Select the day of the week: Press
9. Move the cursor to the next position: Press
10. To change the value: Press
11. To set the correct time of day, repeat steps 9. and 10.
12. To set the correct date, repeat steps 9. and 10.
13. To confirm your entries: Press OK
LOGO!
Manual, 04/2011, A5E03556174-01
Note
The 'Set Clock' command is only executed if your LOGO! is equipped with a real-time
clock (LOGO!..C). You set the real-time clock of LOGO! by means of the 'Set Clock'
command.
LOGO! shows the following display.
7.2 Setting the default values for LOGO!
or
or
or
or
or
Configuring LOGO!
or
295