Siemens LOGO! Series Manual page 108

Programming LOGO!
3.7 Writing and starting the circuit program
6. Select "
7. Select the desired output setting: Press
8. Confirm your entry: Press OK
Defining a specific analog output value
To output a specific analog value at the two analog outputs:
1. Move the '>' cursor to "
2. Confirm ' "
3. Enter a specific output value for each of the two analog outputs.
4. To confirm your entry: Press OK
108
②
": Press OK
LOGO! shows the following display:
The first two rows show your choices. The bottom row shows the current setting for the
analog output channels. The default setting is 'Last'.
You can select either "
③
their last value and "
When LOGO! changes from RUN mode to STOP mode, the values of the analog outputs
change as well, depending on the setting.
③
": Press OK
The display shows:
③ ④ ④
" or " ". " " means that the analog output values are held at
" means that the analog output values are set to specific values.
or .
③
": Press or
Manual, 04/2011, A5E03556174-01
LOGO!