Synchronization - Siemens LOGO! Series Manual

Programming LOGO!
3.7 Writing and starting the circuit program
3.7.15

Synchronization

Time synchronization between LOGO! and a connected communication module EIB/KNX
(version 0AA1 upwards!) can be enabled/disabled
● in parameter assignment mode by means of the set menu ("Clock" menu item)
● in programming mode by means of the setup menu ("Clock" menu item).
When synchronization is enabled, LOGO! can receive the time-of-day from a communication
module EIB/KNX (version 0AA1 upwards).
Whether synchronization is enabled or disabled, the time-of-day is always sent to the
expansion modules at power-up, every hour (STOP mode or RUN mode), and when the time
of day is changed (after a 'Set Clock' is executed or after a summertime/wintertime
conversion).
Note
When using a LOGO! Base Module with digital or analog expansion modules, but without
communication module EIB/KNX (version 0AA1 upwards), time synchronization must not be
activated! You must check whether time synchronization is deactivated ('Sync' must be set to
'Off').
To enable/disable synchronization in programming mode:
1. Switch LOGO! to programming mode. LOGO! displays the main menu.
2. Select "
3. Confirm "
4. Move the '>' cursor to "
5. Confirm "
6. Move the '>' cursor to "
7. Apply "
116
①
": Press or
①
": Press OK
②
": Press
②
": Press OK
③
": Press
③
": Press OK
or
or
Manual, 04/2011, A5E03556174-01
LOGO!