Trane TR200 Programming Manual page 85

P P arameter Description
4-18 Current Limit
Range:
Applica- [Application dependant]
tion de-
pend-
ent*
4-19 Max Output Frequency
Range:
Applica- [1.0 - 1000.0 Hz]
tion de-
pend-
ent*
4-5* Adj. Warnings
Define adjustable warning limits for current, speed, reference and feedback.
NOTE
Not visible in display, only in Trane Drive Utility.
Warnings are shown on display, programmed output or serial bus.
4-50 Warning Current Low
Range:
0.00 A* [Application dependant]
4-48
Function:
Function:
Enter the maximum output frequency value. par.4-19
quency specifies the absolute limit on the adjustable frequency drive
output frequency for improved safety in applications where accidental
overspeeding must be avoided. This absolute limit applies to all config-
urations and is independent of the setting in par.1-00
Mode. This parameter cannot be adjusted while the motor is running.
Function:
Enter the I LOW value. When the motor current falls below this limit
(I LOW ), the display reads CURRENT LOW. The signal outputs can be
programmed to produce a status signal on terminal 27 or 29, and on relay
output 01 or 02. Refer to the drawing in this section.
Max Output Fre-
Configuration
TR200 Programming Guide