Trane TR200 Programming Manual page 137

Parameter Description
[1] Continuously
NOTE: This parameter is active only when par.8-30
8-75 Initialization Password
Range:
Applica- [0 - 0 N/A]
tion de-
pend-
ent*
NOTE: This parameter is active only when par.8-30
8-8* Adjustable Frequency Drive Port Diagnostics
These parameters are used for monitoring the bus communication via the Adjustable Frequency Drive Port.
8-80 Bus Message Count
Range:
0 N/A* [0 - 0 N/A]
8-81 Bus Error Count
Range:
0 N/A* [0 - 0 N/A]
8-82 Slave Messages Rcvd
Range:
0 N/A* [0 - 0 N/A]
8-83 Slave Error Count
Range:
0 N/A* [0 - 0 N/A]
8-84 Slave Messages Sent
Range:
0 N/A* [0 - 0 N/A]
8-85 Slave Timeout Errors
Range:
0 N/A* [0 - 0 N/A]
4-100
Choose whether the device should send the "I-Am" service message only
at power-up or continuously with an interval of approx. 1 min.
Protocol is set to [9]
Function:
Enter the password needed for execution of Drive Re-initialization from
BACnet.
Protocol is set to [9]
Function:
This parameter shows the number of valid messages detected on the
bus.
Function:
This parameter shows the number of messages with faults (e.g., CRC
fault), detected on the bus.
Function:
This parameter shows the number of valid messages addressed to the
slave, sent by the adjustable frequency drive.
Function:
This parameter shows the number of error messages, which could not
be executed by the adjustable frequency drive.
Function:
Function:
Option
.
Drive Option
.
TR200 Programming Guide