Trane TR200 Programming Manual page 116

5-56 Term. 33 High Frequency
Range:
100 Hz* [0 - 110000 Hz]
5-57 Term. 33 Low Ref./Feedb. Value
Range:
0.000 N/ [-999999.999 - 999999.999
A* N/A]
5-58 Term. 33 High Ref./Feedb. Value
Range:
100.000 [-999999.999 - 999999.999
N/A* N/A]
5-59 Pulse Filter Time Constant #33
Range:
100 ms* [1 - 1000 ms]
5-6* Pulse Outputs
Parameters for configuring the scaling and output functions of pulse outputs. The pulse outputs are designated
for terminals 27 or 29. Select terminal 27 output in par.5-01
5-02 Terminal 29 Mode.
Options for readout output variables:
TR200 Programming Guide
Function:
Enter the high frequency corresponding to the high motor shaft speed
(i.e., high reference value) in par.5-58
Function:
Enter the low reference value [RPM] for the motor shaft speed. This is
also the low feedback value, see also par.5-52
Value.
Function:
Enter the high reference value [RPM] for the motor shaft speed. See also
par.5-53 Term. 29 High Ref./Feedb.
Function:
Enter the pulse filter time constant. The low-pass filter reduces the in-
fluence on, and dampens oscillations in, the feedback signal from the
control.
This is an advantage, if, for example, there is a great amount of noise in
the system. This parameter cannot be adjusted while the motor is run-
ning.
Terminal 27 Mode
Parameter Description
Term. 33 High Ref./Feedb.
Term. 29 Low Ref./Feedb.
Value.
and terminal 29 output in par.
Value.
4-79