Trane TR200 Programming Manual page 40

0-02 Motor Speed Unit
Option:
[0] RPM
[1] * Hz
0-03 Regional Settings
Option:
[0] * International
[1] North America
The setting not used is made invisible.
0-04 Operating State at Power-up
Option:
[0] * Resume
[1] Forced stop, ref=old
TR200 Programming Guide
Function:
This parameter cannot be adjusted while the motor is running.
The display showing depends on settings in par.0-02
and par.0-03 Regional Settings. The default setting of par.0-02
Speed Unit and par.0-03 Regional Settings
the world the adjustable frequency drive is supplied to, but can be re-
programmed as required.
NOTE
Motor Speed Unit
Changing the
value. It is recommended to select the motor speed unit first before modifying
other parameters.
Selects display of motor speed variables and parameters (i.e. references,
feedbacks and limits) in terms of motor speed (RPM).
Selects display of motor speed variables and parameters (i.e., referen-
ces, feedbacks and limits) in terms of output frequency to the motor (Hz).
Function:
This parameter cannot be adjusted while the motor is running.
The display showing depends on settings in par.0-02
and par.0-03 Regional Settings. The default setting of par.0-02
Speed Unit and par.0-03 Regional Settings
the world the adjustable frequency drive is supplied to but can be re-
programmed as required.
Sets par.1-20 Motor Power [kW]
par.1-23 Motor Frequency [50 Hz].
Sets par.1-21 Motor Power [HP]
1-23 Motor Frequency to 60 Hz.
Function:
Select the operating mode upon reconnection of the adjustable frequen-
cy drive to AC line voltage after power-down when operating in hand
(local) mode.
Resumes operation of the adjustable frequency drive maintaining the
same local reference and the same start/stop condition (applied by [Hand
On]/[Off] on the keypad or Hand Start via a digital input as before the
adjustable frequency drive was powered down.
Uses saved reference [1] to stop the adjustable frequency drive but at the
same time retain in memory the local speed reference prior to power-
down. After AC line voltage is reconnected and after receiving a start
command (using the keypad [Hand On] button or Hand Start command
via a digital input), the adjustable frequency drive restarts and operates
at the retained speed reference.
Parameter Description
Motor Speed Unit
depends on which region of
will reset certain parameters to their initial
Motor Speed Unit
depends on which region of
units to [kW] and the default value of
units to HP and the default value of par.
Motor
Motor
4-3