Device Messages - Paradyne FrameSaver FLEX 9123 User Manual

Device Messages

These messages appear in the messages area at the bottom of the screens.
All device messages are listed in alphabetical order.
Table 5-5.
9123-A2-GB20-20
Device Messages (1 of 5)
Message What It Indicates
Access level is n , User's access level is 2
Read-only. or 3; user is not authorized
to change configurations.
Already Active Test selected is already
running.
Blank Entries New had been selected
Removed from the Administer Logins
screen, no entry was made,
then Save was selected.
Cannot delete Trap Delete was selected from
Manager the Management PVCs
Options screen, but the
PVC had been defined as a
trap destination.
Cannot Save – no Security was being set up,
Level 1 Login IDs but all the logins were
assigned either Level-2 or
Level-3 access.
Command Complete Configuration has been
saved or all tests have been
aborted.
Connection Refused Two menu-driven user
interface sessions are
(Seen at an FTP
already in use when a
terminal.)
Telnet session was
attempted.
Destination Not Destination entered is
Unique already being used.
DLCI in connection. User tried to delete a DLCI
Delete connection first that was part of a
connection.
DLCI Number Already The DLCI number entered
Exists on the DLCI Record Entry
screen has already been
created so is not unique.
DLCI Number User tried to designate a
Reserved special troubleshooting
DLCI.
August 2001
5. Operation and Maintenance
What To Do
No action is needed.
T
Allow test to continue.
T
Select another test.
T
Stop the test.
T
No action is needed.
T
Reenter the Login ID,
Password, and Access Level.
No action needed, or configure
another path for traps and try
again.
Set up at least one login with
Access Level-1 so the unit can be
configured.
No action is needed.
Wait and try again.
Enter another destination
indicator.
T
No action needed, or
T
Delete the connection, then
delete the DLCI.
Enter another DLCI number.
No action is needed.
5-7