Paradyne FrameSaver FLEX 9123 User Manual page 19

T
T
T
T
T
T
9123-A2-GB20-20
Auto-Configuration. Provides the following automatic configuration features:
— Time Slot Discovery – For automatic configuration of all network DS0
assignments.
— Frame Relay Discovery – For automatic discovery of network DLCIs and
configuration of a user data port DLCIs, the PVC connection, and a
management PVC, which is multiplexed with user data DLCIs.
— LMI Protocol Discovery – For automatic configuration of the protocol being
used by the network.
— DLCI Deletion – For automatic removal of configuration of unused DLCIs
from the unit's configuration and statistical databases.
— CIR Determination – For automatic recalculation of the committed rate
measurement interval (Tc) and excess burst size (Be) when a DLCI's CIR
changes.
— Excess burst size (Be) and committed burst size (Bc) are recalculated
when Committed Burst Size Bc (Bits) is set to CIR. The committed rate
measurement interval (Tc) is recalculated when Committed Burst Size Bc
(Bits) is set to Other.
Configurable FTP Transfer Rate. Allows you to control the transmit rate used
for downloading from the FrameSaver unit and uploading user history statistics
to an NMS (Network Management System) via the COM port connection or a
management PVC so the data can be transferred as a background task using
the standard File Transfer Protocol (FTP) over extended periods using low
bandwidth.
Dual Flash Memory. Allows software upgrades while the unit is up and
running. Two software loads can be stored and implemented at the user's
discretion.
Multiplexed Management PVCs. Provides a method of multiplexing
management data with customer data transparently over a single PVC
(Permanent Virtual Circuit) when FrameSaver devices are at each end of the
circuit. This feature also makes it possible to run nondisruptive PVC tests.
Maximum Number of PVCs and Management PVCs Supported.
Feature
Through Connections (PVCs)
Dedicated Management PVCs
ATM VPI/VCI and DLCI Correlation. For networks with both ATM and frame
relay-access endpoints, allows the FrameSaver unit to report the originating
Virtual Path and Channel Identifier (VPI/VCI) in the far-end ATM-access
endpoint where the local DLCI is mapped. This occurs when the FrameSaver
unit is operating in frame relay mode.
August 2001
1. About the FrameSaver FLEX 9123
Models
9123-A1-213 9123-A1-215
9123-A1-223 9123-A1-225
64 120
2 2
1-5