Paradyne FrameSaver FLEX 9123 User Manual page 120

5. Operation and Maintenance
Table 5-5.
5-10
Device Messages (4 of 5)
Message What It Indicates
No Primary New or Modify was selected
Destination Link DLCIs from the PVC Connection
Available Table, but even though
DLCIs are available to form
a connection, no DLCIs are
available on the network
link, which is a suitable
Primary PVC Destination.
No Security Records Delete was selected from
to Delete the Administer Login
screen, and no security
records had been defined.
Password Matching Password entered in the
Error – Re-enter Re-enter Password field of
Password the Administer Logins
screen does not match what
was entered in the
Password field.
Permission Denied A file transfer was
attempted, but the:
(Seen at an FTP
T
terminal.)
T
T
Please Wait Command takes longer
than 5 seconds.
Port Inactive The port is disabled, or it
supports synchronous data
and is configured for leased
line mode when a DTE
Loopback was started.
Resetting Device, Yes (or y) was entered in
Please Wait ... the Reset COM Port
usage field of the System
Paused menu.
August 2001
What To Do
Configure additional DLCIs for the
network link and try again.
If a network DLCI has been
entered as a Source DLCI:
1. Change the Source DLCI to a
2. Enter the network DLCI as the
T
T
T
T
T
User did not have
Level 1 security.
T
Wrong file was specified
when the put command
was entered.
T
User attempted to
upload a program file
from the unit.
Wait until message clears.
No action is needed.
No action is needed.
user data port DLCI.
PVC's Primary Destination.
No action is needed.
Enter a security record.
Try again.
Contact your system
administrator to verify your
password.
See your system administrator
to get your security level
changed.
Try again, entering the correct
file with the put command.
Enter the put command
instead of a get command; you
can only transfer files to the
unit, not from it.
See Upgrading System
Software on page 5-42.
9123-A2-GB20-20