Limiting Telnet Or Ftp Access Over The Ts Management Link - Paradyne FrameSaver FLEX 9123 User Manual

Limiting Telnet or FTP Access Over the TS Management Link

Procedure
To limit Telnet or FTP access when the session is on the TS Management Link:
See
Information
configuration options.
9123-A2-GB20-20
1. Select the Telnet and FTP Session options.
Main Menu → Configuration → Management and Communication →
Telnet and FTP Sessions
2. Disable Telnet Session and/or FTP Session, as appropriate.
3. Return to the Management and Communication menu, and select Node IP.
4. Set the following configuration options, as appropriate.
To . . .
Disable access via the TS Access
Management Link
Assign an access level to the TS
Access Management Link
5. Save your changes.
Configuring Telnet and/or FTP Session Support
in Chapter 3, Configuration, for more information about these
August 2001
4. Security and Logins
Set the configuration option . . .
TS Access Management Link to None.
TS Management Access Level to Level-2
or Level-3.
NOTE: Regardless of a user's login access
level, a user cannot operate at a level higher
than the access level specified for the session
(e.g., if a user has a Level-1 login and Level-2
telnet access has been set, the Level-1 user
can only operate as a Level-2 user).
If you are going to allow users to configure the
unit, keep the access at Level-1.
or Configuring Node IP
4-7