Table of Contents
Advertisement
Test Timeout Feature
A Test Timeout feature is available to automatically terminate a test (as opposed to
manually terminating a test) after it has been running a specified period of time.
It is recommended that this feature be used when the FrameSaver unit is remotely
managed through an inband data stream (PVC). If a test is accidently commanded
to execute on the interface providing management access, control is regained
when the specified time period expires, automatically terminating the test.
To use this feature, enable the Test Timeout configuration option, and set a
duration for the test to run in the Test Duration (min) configuration option (see
Configuring General System Options
Starting and Stopping a Test
Use this procedure to start, monitor, or abort specific tests. To abort all active tests
on all interfaces, see
Start or stop an individual test using the same procedure.
9123-A2-GB20-20
NOTE:
These configuration options do not pertain to tests commanded by the DTE,
like a DTE-initiated External Loopback.
Aborting All Tests
When the status of a test is . . .
Inactive
Active
NOTE:
If the Service Type setting on the Easy Install screen changes, all currently
active tests are stopped.
August 2001
in Chapter 3, Configuration ).
on page 6-16.
The only command available is . . .
Start
Stop
6. Troubleshooting
6-15
Advertisement
Table of Contents
Troubleshooting
