Paradyne FrameSaver FLEX 9123 User Manual page 121

Table 5-5.
9123-A2-GB20-20
Device Messages (5 of 5)
Message What It Indicates
Save Cancelled Changes were made on the
Easy Install screen, but
when it came to saving the
changes, the Esc key was
pressed or No was entered
in response to the Save
Changes? prompt.
Test Active No higher priority health
and status messages exist,
and a test is running.
User Interface Two Telnet sessions are
Already in Use already in use when an
attempt to access the
menu-driven user interface
through the COM port is
made.
IP addresses and logins of
the users currently
accessing the interface are
also provided.
User Interface Idle Previously active session is
now closed/ended, and
access via the COM port is
now available.
Session has been ended
due to timeout.
Value Out of Range CIR entered for the DLCI is
a number greater than the
maximum allowed.
Excess Burst Size entered
for the DLCI is a number
greater than the maximum
allowed.
DLCI Number entered is
less than 16 or greater
than 1007.
August 2001
5. Operation and Maintenance
What To Do
No action is needed.
T
Contact service provider if test
initiated by the network.
T
Wait until the test ends and
message clears.
T
Cancel all tests from the Test
screen (Path: main/test).
T
Stop the test from the same
screen the test was started
from.
T
Wait and try again.
T
Contact one of the IP address
user and request that they log
off.
Log on to the FrameSaver unit.
No action is needed.
Enter a valid CIR (0 – 1536000).
Enter a valid Excess Burst Size
(0 – 1536000).
Enter a valid number (16 – 1007).
5-11