Suzuki Ignis Service Manual page 1850

Result Table (For RM413D)
Result Cause Of Fault
E01 • Defective component:
Brake Light Switch
or
ECM
NOTE:
• The replacement of the components must be done in the listed order.
The system must be checked for proper operation after every replacement.
• If ECM is replaced, register vehicle specification into ECM by performing procedure
described in "ECM registration" in Section 6E3.
E02 • Circuit interruption between:
Brake Light Switch – Wiring harness connector (wiring harness side) terminal E36-3
&
ECM – Wiring harness connector (wiring harness side) terminal E27-68
E03 • Short circuit to voltage between:
Brake Light Switch – Wiring harness connector (wiring harness side) terminal E36-3
&
ECM – Wiring harness connector (wiring harness side) terminal E27-68
E04 • Circuit interruption between:
Brake Light Switch – Wiring harness connector (wiring harness side) terminal E36-2
&
ECM – Wiring harness connector (wiring harness side) terminal E27-81
or
• Defective component:
ECM
NOTE:
If ECM is replaced, register vehicle specification into ECM by performing procedure
described in "ECM registration" in Section 6E3.
E05 • If the nominal value is reached during one of the measurements, the component/control unit
that has been disconnected immediately before that measurement is defective.
E06 • Short circuit to voltage between:
Brake Light Switch – Wiring harness connector (wiring harness side) terminal E36-2
&
ABS Control Module – Wiring harness connector (wiring harness side) terminal E43-3
&
ECM – Wiring harness connector (wiring harness side) terminal E27-81
&
Rear Combination Lamp (Left) – Wiring harness connector (wiring harness side) terminal L02-4
&
Rear Combination Lamp (Right) – Wiring harness connector (wiring harness side) terminal L01-
4
&
High Mount Stop Light – Wiring harness connector (wiring harness side) terminal O02-1
ENGINE GENERAL INFORMATION AND DIAGNOSIS (Z13DT ENGINE) 6-3-191