Suzuki Ignis Service Manual page 1831

6-3-172 ENGINE GENERAL INFORMATION AND DIAGNOSIS (Z13DT ENGINE)
Result Table (For RB413D)
Result Cause Of Fault
E01 • Defective component:
Fuel Pressure Sensor
or
ECM
NOTE:
• The replacement of the components must be done in the listed order.
The system must be checked for proper operation after every replacement.
• If ECM is replaced, register vehicle specification into ECM by performing procedure
described in "ECM registration" in Section 6E3.
E02 • Circuit interruption between:
ECM – Wiring harness connector (wiring harness side) terminal D26-38
&
Fuel Pressure Sensor – Wiring harness connector (wiring harness side) terminal D28-3
E03 • Short circuit to ground between:
Fuel Pressure Sensor – Wiring harness connector (wiring harness side) terminal D28-3
&
ECM – Wiring harness connector (wiring harness side) terminal D26-38
E04 • Short circuit to voltage between:
Fuel Pressure Sensor – Wiring harness connector (wiring harness side) terminal D28-3
&
ECM – Wiring harness connector (wiring harness side) terminal D26-38
E05 • Short circuit to voltage/interruption of circuit between:
ECM – Wiring harness connector (wiring harness side) terminal D26-6
&
Fuel Pressure Sensor – Wiring harness connector (wiring harness side) terminal D28-2
or
• Defective component:
ECM
NOTE:
If ECM is replaced, register vehicle specification into ECM by performing procedure
described in "ECM registration" in Section 6E3.
E06 • Short circuit to voltage between:
ECM – Wiring harness connector (wiring harness side) terminal D26-8
&
Fuel Pressure Sensor – Wiring harness connector (wiring harness side) terminal D28-1
or
• Defective component:
ECM
NOTE:
If ECM is replaced, register vehicle specification into ECM by performing procedure
described in "ECM registration" in Section 6E3.