Suzuki Ignis Service Manual page 1669

6-3-10 ENGINE GENERAL INFORMATION AND DIAGNOSIS (Z13DT ENGINE)
Test Work Order Description
T09 System/Function End Test
• Check if the customer complaint is repaired and the concerned
system is fully operational.
NOTE:
Drive the vehicle in different driving conditions (engine speed
and engine load conditions) over a considerable distance. Pay
attention to unusual noise and other system irregularities.
• Turn ignition OFF and ON
• Delete trouble codes
NOTE:
Read the trouble codes again after the test drive and check for
symptoms/customer complaints. If a complaint still exists,
restart the diagnostic session for a second time. If the problem
can not be solved in the second diagnostic session, contact the
local support centre.
Yes: –
T10 Intermittent System Operation
Most intermittent problems are caused by faulty electrical connectors,
faulty ground connections, broken wiring, temperature problems or
radio interference.
Intermittent faults can be traced either by using history trouble codes
or the snapshot function of the scan tool in combination with the fol-
lowing tests:
• Perform the following evaluation:
Refer to Table B-18, Check: Intermittent Faults
• After successful test/fault repair proceed to the next test step
Yes: T09
Nominal Value
No: –
No: –