Suzuki Ignis Service Manual page 1468

Troubleshooting
Step
1 Was "Automatic Transaxle Diagnostic Flow
Table" in this section performed?
2 Check Output Shaft Speed Sensor (VSS)
Power Circuit.
1) Turn ignition switch OFF.
2) Disconnect output shaft speed sensor con-
nector.
3) Turn ignition switch ON.
4) Measure voltage between "BLK/RED" wire
terminal of disconnected output shaft
speed sensor harness side connector and
ground.
Is it 10 – 14 V?
3 Check Output Shaft Speed Sensor (VSS)
Ground Circuit.
1) Turn ignition switch OFF.
2) Check continuity between "BLK/ORN" wire
terminal of disconnected output shaft
speed sensor harness side connector and
ground.
Is continuity indicated?
4 Check Output Shaft Speed Sensor (VSS) Sig-
nal Circuit for short.
1) Disconnect TCM connectors.
2) Check continuity between "YEL" wire termi-
nal of disconnected output shaft speed
sensor harness side connector and ground.
Is continuity indicated?
5 Check Output Shaft Speed Sensor (VSS) Sig-
nal Circuit for open.
1) Check continuity between "YEL" wire termi-
nal of disconnected output shaft speed
sensor harness side connector and termi-
nal C38-25 of disconnected harness side
TCM connector.
Is continuity indicated?
6 Inspect Output Shaft Speed Sensor (VSS).
Inspect output shaft speed sensor referring to
"Output Shaft Speed Sensor (VSS)" in this sec-
tion.
Is check result satisfactory?
Action Yes
Go to Step 2.
Go to Step 3.
Go to Step 4.
"YEL" wire shorted to
ground.
Go to Step 6.
Go to Step 7.
AUTOMATIC TRANSAXLE 7B-63
No
Go to "Automatic Tran-
saxle Diagnostic Flow
Table" in this section.
"BLK/RED" wire open or
shorted to ground.
"BLK" wire open.
Go to Step 5.
"YEL" wire open.
Replace output shaft
speed sensor.