Suzuki Ignis Service Manual page 1774

Result Table (For RM413D)
Result Cause Of Fault
E01 • Defective component:
MAF and IAT Sensor
E02 • If the nominal value is reached during one of the measurements, the component/control unit
that has been disconnected immediately before that measurement is defective.
E03 • Short circuit to ground/interruption of circuit between:
MAF and IAT Sensor – Wiring harness connector (wiring harness side) terminal C79-4
&
ECM – Wiring harness connector (wiring harness side) terminal C66-40
or
Camshaft Position Sensor – Wiring harness connector (wiring harness side) terminal C69-3
&
ECM – Wiring harness connector (wiring harness side) terminal C66-25
or
Pedal Position Sensor – Wiring harness connector (wiring harness side) terminal E25-5
&
ECM – Wiring harness connector (wiring harness side) terminal E27-83
or
• Defective component:
ECM
NOTE:
If ECM is replaced, register vehicle specification into ECM by performing procedure
described in "ECM registration" in Section 6E3.
E04 • Short circuit to voltage between:
MAF and IAT Sensor – Wiring harness connector (wiring harness side) terminal C79-4
&
ECM – Wiring harness connector (wiring harness side) terminal C66-40
or
Pedal Position Sensor – Wiring harness connector (wiring harness side) terminal E25-5
&
ECM – Wiring harness connector (wiring harness side) terminal E27-83
or
Camshaft Position Sensor – Wiring harness connector (wiring harness side) terminal C69-3
&
ECM – Wiring harness connector (wiring harness side) terminal C66-25
or
• Defective component:
ECM
NOTE:
If ECM is replaced, register vehicle specification into ECM by performing procedure
described in "ECM registration" in Section 6E3.
ENGINE GENERAL INFORMATION AND DIAGNOSIS (Z13DT ENGINE) 6-3-115