Suzuki Ignis Service Manual page 1844

Result Table (For RB413D)
Result Cause Of Fault
E01 • Defective component:
Camshaft Position Sensor
or
ECM
NOTE:
The replacement of the components must be done in the listed order.
The system must be checked for proper operation after every replacement.
NOTE:
If ECM is replaced, register vehicle specification into ECM by performing procedure
described in "ECM registration" in Section 6E3.
E02 • Repair the concerned circuit/component.
E03 • Short circuit to voltage between:
ECM – Wiring harness connector (wiring harness side) terminal D26-56
&
Camshaft Position Sensor – Wiring harness connector (wiring harness side) terminal D33-2
or
• Defective component:
ECM
NOTE:
If ECM is replaced, register vehicle specification into ECM by performing procedure
described in "ECM registration" in Section 6E3.
E04 • Short circuit to ground/interruption of circuit between:
ECM – Wiring harness connector (wiring harness side) terminal D26-56
&
Camshaft Position Sensor – Wiring harness connector (wiring harness side) terminal D33-2
or
• Defective component:
ECM
NOTE:
If ECM is replaced, register vehicle specification into ECM by performing procedure
described in "ECM registration" in Section 6E3.
E05 • Circuit interruption between:
ECM – Wiring harness connector (wiring harness side) terminal D26-21
&
Camshaft Position Sensor – Wiring harness connector (wiring harness side) terminal D33-3
or
• Defective component:
ECM
NOTE:
If ECM is replaced, register vehicle specification into ECM by performing procedure
described in "ECM registration" in Section 6E3.
ENGINE GENERAL INFORMATION AND DIAGNOSIS (Z13DT ENGINE) 6-3-185