Table of Contents
Advertisement
7B-192 AUTOMATIC TRANSAXLE
"A"
46) Remove sealant attached to mating surface of transaxle rear
cover (1) completely.
47) Apply sealant to mating surface of transaxle rear cover (1)
by using a nozzle (2) as shown in figure by such amount that
2
its section is 1.2 mm (0.047 in.) in diameter.
"A": Sealant 99000-31230
1
48) Install transaxle rear cover assembly on transaxle case.
49) Install hook (2) to location shown in figure.
Tightening torque
Rear cover bolts
(a): 25 N·m (2.5 kg-m, 18.0 lb-ft)
50) Tighten rear cover bolts (1).
51) Install fluid reservoir LH plate (1).
Tightening torque
Fluid reservoir LH plate bolt
(a): 10 N·m (1.0 kg-m, 7.5 lb-ft)
52) After applying A/T fluid to new governor apply No.2 gasket
(1), install it to transaxle case.
53) After applying A/T fluid to differential assembly (1) and coun-
tershaft assembly (2), install them to transaxle case.
Advertisement
Table of Contents
