Table of Contents
Advertisement
Test
Work Order Description
T10
Check: Short to Voltage/Ground/Interruption of Voltage Supply
• Ignition OFF
• Disconnect wiring harness connector from:
Pedal Position Sensor
• Ignition ON
• Measure voltage between the following terminals:
Pedal Position Sensor – Wiring harness connector (wiring harness side)
terminal G82-5
&
Ground
Yes: E10
ENGINE GENERAL INFORMATION AND DIAGNOSIS (Z13DT ENGINE) 6-3-135
Nominal Value
greater than 5.2 V
No: E11
Advertisement
Table of Contents
