Suzuki Ignis Service Manual page 1492

1
2
3
Terminal Arrangement of TCM Coupler (Viewed From Harness Side)
Con- Terminal
Wire color
nector number
1
C38
2
3
4
5
Inspection of TCM and Its Circuits
TCM and its circuits can be checked at TCM wiring connectors by
measuring voltage and resistance.
INSPECTION
Circuit
Transmission range sen-
RED
sor ("R" range)
– –
– –
– –
– –
CAUTION:
TCM cannot be checked by itself, it is strictly prohibited
to connect voltmeter or ohmmeter to TCM with connector
disconnected from it.
1) Remove TCM (1) from vehicle referring to "Transmission
Control Module (TCM)" in this section.
2) Connect TCM connectors (2) to TCM.
3) Check voltage at each terminal of connectors connected.
NOTE:
As each terminal voltage is affected by battery voltage,
confirm that it is 11 V or more when ignition switch is ON.
3. Body ground
Normal
Voltage
8 – 14 V
0 – 1 V
–
–
–
–
AUTOMATIC TRANSAXLE 7B-87
Condition
Ignition switch ON, selector lever at
"R" range
Ignition switch ON, selector lever at
other than "R" range
–
–
–
–