Suzuki Ignis Service Manual page 1840

C-20, Camshaft Position Sensor Circuit
Test Table (For RM413D)
Test Work Order Description
T01 Check: Interruption of Signal Circuit
• Ignition OFF
• Disconnect wiring harness connector from:
Camshaft Position Sensor
• Ignition ON
• Measure voltage between the following terminals:
Camshaft Position Sensor – Wiring harness connector (wiring harness
side) terminal C69-3
&
Ground
Yes: T02
T02 Check: Interruption of Signal Circuit
• Measure voltage between the following terminals:
Camshaft Position Sensor – Wiring harness connector (wiring harness
side) terminal C69-3
&
Camshaft Position Sensor – Wiring harness connector (wiring harness
side) terminal C69-1
Yes: T03
T03 Check: Short to Voltage/Ground/Interruption of Signal Circuit
• Measure voltage between the following terminals:
Camshaft Position Sensor – Wiring harness connector (wiring harness
side) terminal C69-2
&
Ground
Yes: T04
T04 Check: Adjustment
• Check the following component for proper operation:
Camshaft Position Sensor (intermittent problems, missing teeth, wrong
reference point, incorrect gap position, etc.)
Yes: E01
T05 Check: Short to Voltage/Ground/Interruption of Signal Circuit
• Measure voltage between the following terminals:
Camshaft Position Sensor – Wiring harness connector (wiring harness
side) terminal C69-2
&
Ground
Yes: E03
ENGINE GENERAL INFORMATION AND DIAGNOSIS (Z13DT ENGINE) 6-3-181
Nominal Value
4.8 ... 5.2 V
No: E06
4.8 ... 5.2 V
No: E05
4.8 ... 5.2 V
No: T05
Test okay?
No: E02
greater than 5.2 V
No: E04