Suzuki Ignis Service Manual page 1838

Test Work Order Description
T06 Check: Short to Ground of Signal Circuit
• Measure resistance between the following terminals:
ECM – Wiring harness connector (wiring harness side) terminal D26-4
&
Fuel Pressure Regulator – Wiring harness connector (wiring harness
side) terminal D30-1
Yes: T07
T07 Check: Interruption of Signal Circuit
• Disconnect wiring harness connector from:
ECM (Wiring Harness Connector G88)
• Connect fused jumper wire to:
ECM – Wiring harness connector (wiring harness side) terminal G88-80
&
Ground
• Measure voltage between the following terminals:
ECM – Wiring harness connector (wiring harness side) terminal G88-5
&
Ground
Yes: E02
ENGINE GENERAL INFORMATION AND DIAGNOSIS (Z13DT ENGINE) 6-3-179
Nominal Value
less than 5 kOhm
No: E06
greater than 11 V
No: E05