Suzuki Ignis Service Manual page 1705

6-3-46 ENGINE GENERAL INFORMATION AND DIAGNOSIS (Z13DT ENGINE)
B-19, Programming ECM
Test Work Order Description
T01 Programming
The following tests must be performed in the given order:
• The following programing function has to be performed to program
the fuel injector calibration code.
– Refer to Table B-06 Programming "T03" Replace Injector
• After programming successfully, check if the system malfunction is
still present.
• If the malfunction is still present, continue with the following tests:
• With trouble code P0602 recognized:
Refer to Table C-02, Control Unit Hard- and Software
• After successful test/fault repair proceed to the next test step
Yes: –
Nominal Value
No: –