Suzuki Ignis Service Manual page 1796

Result Cause Of Fault
E07 • Short circuit to voltage between:
ECM – Wiring harness connector (wiring harness side) terminal G88-65
&
Pedal Position Sensor – Wiring harness connector (wiring harness side) terminal G82-4
or
• Defective component:
ECM
NOTE:
If ECM is replaced, register vehicle specification into ECM by performing procedure
described in "ECM registration" in Section 6E3.
E08 • Circuit interruption between:
ECM – Wiring harness connector (wiring harness side) terminal G88-65
&
Pedal Position Sensor – Wiring harness connector (wiring harness side) terminal G82-4
or
• Defective component:
ECM
NOTE:
If ECM is replaced, register vehicle specification into ECM by performing procedure
described in "ECM registration" in Section 6E3.
E09 • Circuit interruption between:
Pedal Position Sensor – Wiring harness connector (wiring harness side) terminal G82-3
&
ECM – Wiring harness connector (wiring harness side) terminal G88-35
or
• Defective component:
ECM
NOTE:
If ECM is replaced, register vehicle specification into ECM by performing procedure
described in "ECM registration" in Section 6E3.
E10 • Short circuit to voltage between:
ECM – Wiring harness connector (wiring harness side) terminal G88-83
&
Pedal Position Sensor – Wiring harness connector (wiring harness side) terminal G82-5
or
• Defective component:
ECM
NOTE:
If ECM is replaced, register vehicle specification into ECM by performing procedure
described in "ECM registration" in Section 6E3.
ENGINE GENERAL INFORMATION AND DIAGNOSIS (Z13DT ENGINE) 6-3-137