Suzuki Ignis Service Manual page 1862

Test Table (For RB413D)
Test Work Order Description
T01 Check: Interruption of Signal Circuit
• Ignition OFF
• Disconnect wiring harness connector from:
Clutch Switch
• Ignition ON
• Measure voltage between the following terminals:
Clutch Switch – Wiring harness connector (wiring harness side) terminal
G85-2
&
Ground
Yes: T02
T02 Check: Short to Ground of Signal Circuit
• Ignition OFF
• Disconnect harness connector from:
ECM
• Ignition ON
• Measure voltage between the following terminals
ECM – Wiring harness connector (wiring harness side) terminal G88-22
&
Ground
Yes: T03
T03 Check: Short to Voltage/Interruption of Signal Circuit
• Ignition OFF
• Connect fused jumper wire to:
Clutch Switch – Wiring harness connector (wiring harness side) terminal
G85-1
&
Clutch Switch – Wiring harness connector (wiring harness side) terminal
G85-2
• Ignition ON
• Measure voltage between the following terminals
ECM – Wiring harness connector (wiring harness side) terminal G88-22
&
Ground
Yes: E01
ENGINE GENERAL INFORMATION AND DIAGNOSIS (Z13DT ENGINE) 6-3-203
Nominal Value
greater than 11 V
No: E04
less than 0.3 V
No: E03
greater than 11 V
No: E02