Suzuki Ignis Service Manual page 1804

Result Table (For RB413D)
Result Cause Of Fault
E01 • Defective component:
Boost Pressure Sensor
or
ECM
NOTE:
• The replacement of the components must be done in the listed order.
The system must be checked for proper operation after every replacement.
• If ECM is replaced, register vehicle specification into ECM by performing procedure
described in "ECM registration" in Section 6E3.
E02 • Short circuit to ground between:
Boost Pressure Sensor – Wiring harness connector (wiring harness side) terminal D29-1
&
ECM – Wiring harness connector (wiring harness side) terminal D26-41
E03 • Circuit interruption between:
Boost Pressure Sensor – Wiring harness connector (wiring harness side) terminal D29-1
&
ECM – Wiring harness connector (wiring harness side) terminal D26-41
E04 • Short circuit to voltage between:
Boost Pressure Sensor – Wiring harness connector (wiring harness side) terminal D29-1
&
ECM – Wiring harness connector (wiring harness side) terminal D26-41
or
• Defective component:
ECM
NOTE:
If ECM is replaced, register vehicle specification into ECM by performing procedure
described in "ECM registration" in Section 6E3.
E05 • Circuit interruption between:
Boost Pressure Sensor – Wiring harness connector (wiring harness side) terminal D29-2
&
ECM – Wiring harness connector (wiring harness side) terminal D26-24
or
• Defective component:
ECM
NOTE:
If ECM is replaced, register vehicle specification into ECM by performing procedure
described in "ECM registration" in Section 6E3.
E06 • Short circuit to voltage between:
ECM – Wiring harness connector (wiring harness side) terminal D26-24
&
Boost Pressure Sensor – Wiring harness connector (wiring harness side) terminal D29-2
ENGINE GENERAL INFORMATION AND DIAGNOSIS (Z13DT ENGINE) 6-3-145