Suzuki Ignis Service Manual page 1648

WARNING:
For vehicles equipped with Supplemental Restraint (Air Bag) System:
• Service on and around the air bag system components or wiring must be performed only by an
authorized SUZUKI dealer. Refer to "System Components and Wiring Location View and Connec-
tors" under "General Description" in Section 10B in order to confirm whether you are performing
service on or near the air bag system components or wiring. Please observe all WARNINGS and
"Service Precautions" under "On-Vehicle Service" in Section 10B before performing service on or
around the air bag system components or wiring. Failure to follow WARNINGS could result in unin-
tentional activation of the system or could render the system inoperative. Either of these two condi-
tions may result in severe injury.
• Technical service work must be started at least 90 seconds after the ignition switch is turned to the
"LOCK" position and the negative cable is disconnected from the battery. Otherwise, the system
may be activated by reserve energy in the Sensing and Diagnostic Module (SDM).
• When body servicing, if shock may be applied to air bag system component parts, remove those
parts beforehand. (Refer to Section 10B.)
NOTE:
• Fasteners are important attaching parts in that they could affect the performance of vital compo-
nents and systems, and/or could result in major repair expense. They must be replaced with one of
the same part number of with an equivalent part if replacement becomes necessary.
• Do not use a replacement part of lesser quality or substitute a design. Torque values must be used
as specified during reassembly to assure proper retention of these parts.
• For the items with asterisk (*) in the "CONTENTS" below, refer to the same section of the Service
Manual mentioned in the "Foreword" of this manual.
Glass, Windows and Mirrors................................ *
Front Door Window Removal and
Installation ........................................................... *
Front Door Window Inspection............................ *
Front Door Window Regulator Removal
and Installation .................................................... *
Front Door Window Regulator Inspection ........... *
Door Mirror Removal and Installation.................. *
Rear Door Window Removal and
Installation ........................................................... *
Rear Door Window Inspection ............................ *
Rear Door Window Regulator Removal
and Installation .................................................... *
Rear Door Window Regulator Inspection............ *
Windshield Removal and Installation .................. *
Preparation...................................................... *
Quarter Window Removal and Installation.......... *
Rearend Glass Removal and Installation............ *
Body Structure ...................................................... *
SECTION 9
BODY SERVICE
CONTENTS
Front Door Removal and Installation .................. *
Rear Door Removal and Installation ................... *
Rearend Door Removal and Installation ............. *
Hood Removal and Installation ........................... *
Hood Adjustment ................................................ *
Hood Inspection .................................................. *
Front Fender Removal and Installation............... *
Front Bumper and Rear Bumper Removal
and Installation.................................................... *
Bumper Extension and Splash Guard
Removal and Installation (If Equipped) ............... *
Rearend Door Spoiler Removal and
Installation (If Equipped) ..................................... *
Roof Rail Removal and Installation
(If Equipped) ....................................................... *
Body Dimensions ................................................ *
Engine room.................................................... *
Rearend door .................................................. *
Side body ........................................................ *
BODY SERVICE 9-1
6E1
7A2
7B
8C1
8G3
9